All the datas shown in the table, have been obtained with accurate tests effectued on any type of staves manufactured by us.

Our technicians are at your fullest disposal for any further informations or assistance you may need.

TRANSPALLETS ON BULGED STAVES SURFACE

The bas reliefs obtained with a bulging operation, give to the staves an high rigidity capable to support loads on transpallets, assuring optimun smoothness and avoidin noises.
The groove and tongue joint is very important while using transpallts. Without this type of joint the stave could bow creating steps between the staves.
The staves must be joined by means of M8 screws positioned in the middle of two subsequent supports. We adwise 4 screws for square meter. In order to have the staves adherent to the supporting structure, it is very usefull to set brackets between the beams and the staves (adwise number of brackets: 1 for square meter).

While applaing a load according to the belt "A", the deformations of the floor are pratically nothing.
The loads of belt "B" determines a deformation on the floor of mm 1. Once we exceed this value the deformations increase rapidly.
For a safety operation, never exceed the load indicated in belt "A".

IMPORTANT

This values appaly for transpallets equipped with two rollers Ø mm 80 width 65 mm made in elastic material (standard wheels)

THE BARYCENTER OF THE LOAD MUST BE PLACED IN THE MIDDLE OF THE TRANSPALLET FORKS.